
19
Operation Guide For G7
Transmission source
•
The source where the signal will
be transmitted
1
Temperature setting
•
To set the desired room
temperature, press the button to
increase or decrease the set
temperature.
• The temperature setting range
is from 16°C to 30°C (Optional
setting 18°C to 30°C).
• Press both buttons
simultaneously to toggle the
temperature setting between °C
and °F.
4
Fan speed selection
•
Press the button until the
desired fan speed is achieved.
6
ON timer setting
•
Press the SET button will
activate the on timer function.
• Set the desired on time by
pressing the SET button
continuously. If the timer is set
to 7.30am, the air conditioner
will turn on at 7.30 sharp.
• Press the CLR button to cancel
the on timer setting.
7
Automatic air swing
•
Press the SWING button to
activate the automatic air swing
function.
• To distribute the air to a specific
direction, press the SWING but-
ton and wait until the louver
move to the desired direction
and press the button once
again.
9
Signal transmission
indication
•
Blink to confirm the last setting
has been send to the unit.
2
On/Off button
•
Press once to start the air
conditioner.
• Press again to stop the unit.
3
Operation mode
•
Press the MODE button to
select the type of operating
mode.
• For cooling only unit, the
available modes are : COOL,
DRY & FAN.
• For heat pump unit, the
available modes are : AUTO,
COOL, DRY, FAN & HEAT.
5
OFF timer setting
•
Press the SET button will
activate the off timer function.
• Set the desired off time by
pressing the SET button
continuously.
• Press the CLR button to cancel
the off timer setting.
8
Sleep mode setting
•
Press the button to activate
sleep mode. This function is
available under COOL, HEAT &
AUTO mode.
• When it is activated in COOL
mode, the set temperature will
be increased 0.5°C after
30mins, 1°C after 1 hour and
2°C after 2 hours.
• When it is activated in HEAT
mode, the set temperature will
be decreased 1°C after 30mins,
2°C after 1 hour and 3°C after 2
hours.
10
Clock time setting
•
Press button + or - to increase
or decrease the clock time.
11
12
Comentarios a estos manuales