McQuay M5WMX Especificaciones descargar pdf (Pagina 21)

Electrical wiring connection

IMPORTANT : The figures shown in the table are for information purpose only. They should be checked and

selected to comply with the local/national codes of regulations. This is also to the type of

installation and conductors used.

INDOOR UNIT D

TERMINAL BLOCK

INDOOR UNIT C

TERMINAL BLOCK

INDOOR UNIT B

TERMINAL BLOCK

INDOOR UNIT A

TERMINAL BLOCK

REWOP

YLPPUS

MAIN CONTROL BOARD EARTH WIRE

FAN EARTH WIRE

POWER SUPPLY

CABLE

CABLE TIE

(PUSH RELEASABLE)

INTERCONNECTION

CABLE

There must be a double pole switch with a

minimum 3 mm contact gap and fuse/

circuit breaker as recommended in the

fixed installation circuit.

• All wiring must be connected accordingly to the diagram

above, with reference to the piping connection. Mismatch

any wiring with different piping will cause severe damage

to the system.

• All wires must be firmly connected.

• All wires must not touch the refrigerant piping,

compressor or any moving parts of the fan motor.

• The connecting wires between the indoor unit and the

outdoor unit must be clamped on the wire clamps and

the cable tie (push releasable) at the indoor unit and

outdoor unit respectively as shown in the figures.

• The power supply cord must be equivalent to H05RN-F

(245IEC57) which is the minimum requirement.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 66 67

Sin comentarios

McQuay M5WMX Especificaciones Pagina 21