Warning
IMPORTANT: DO NOT INSTALL OR USE THE AIR CONDITIONER UNIT IN A LAUNDRY ROOM
• Installation and maintenance should be performed by qualified persons who are familiar
with local code and regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to that of the name plate before
commencing wiring work according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazards due to installation failure.
• All electrical wiring must not touch the refrigerant piping, compressor or any moving parts
of the fan motors.
• Confirm that the unit has been switched OFF before installing or servicing the unit.
• Do not touch the compressor or refrigerant piping without wearing gloves.
Safety Precautions
Before installing the air conditioner unit, please read the following safety precautions carefully
Installation
Caution
Please take note of the following important points when installing.
• Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it may cause fire ignition.
• Ensure that the drainage piping is connected properly.
If the drainage piping is not connected properly, it may cause water leakage which will dampen the
furniture.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.
• Ensure that the units panel is closed after service or installation.
Unsecured panels will cause unit to operate noisily.
13
Comentarios a estos manuales