McQuay M5WMX Especificaciones descargar pdf (Pagina 98)

Fresh Air Intake For M5CKX-C Unit

The direction of the fresh air intake is shown as figure 3.

Sealing Material

• It is possible to seal one of the four air discharge outlet (sealing two or more air discharge outlet could

cause a malfunction).

• Remove the front panel and inserting the seal material into the air discharge outlet at the indoor unit to seal

the air outlet.

• The sealing material is the same length as the length air discharge outlet. If it is desired to seal the shorter

air discharge outlet, cut the sealing material to shorten it.

• Push the sealing material in about 10mm beyond the bottom surface of the indoor unit so that it does not

touch the air louver. Be sure not to push the sealing material in any father than about 10mm.

Take off the panel from the indoor unit

Remove the PE foam from the drain pan and another one

on the unit.

Remove the pre-punched panel on the CKC unit with a

screwdriver.

The diameter of the air intake knock out hole is 65mm.

Then, fix the fresh air kit (refer to parts list) to the hole.

Finally, a flexible duct is connected to let the fresh air moving

in.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 136 137

Sin comentarios

McQuay M5WMX Especificaciones Pagina 98