McQuay M4MC Especificaciones descargar pdf (Pagina 17)

(2) Installation of Outdoor Unit

MMC Series

As condensing temperature rises, evaporating temperature rises and cooling capacity drops. In order to achieve

maximum cooling capacity, the location selected for outdoor unit should fulll the following requirements:

• Install the condensing (outdoor) unit in a way such that hot air distributed by the outdoor condensing unit

cannot be drawn in again (as in the case of short circuit of hot discharge air). Allow sufcient space for main-

tenance around the unit

• Ensure that there is no obstruction of air ow into or out of the unit. Remove obstacles which block air intake

or discharge.

• The location must be well ventilated, so that the unit can draw and distribute plenty of air thus lowering the

condensing temperature.

• A place capable of bearing the weight of the outdoor unit and isolating noise and vibration.

• A place protected from direct sunlight. Otherwise use an awning for protection, if necessary.

• A place where the hot air discharge and operating sound level will not annoy the neighbours.

• The location must not be susceptible to dust or oil mist.

Installation Clearance

• Outdoor units must be installed such that there is no short circuit of the hot discharge air or obstruction to

smooth air ow.

CAUTION : If the condensing unit is operated in an atmosphere containing oils (including machine

oils), salt (coastal area), sulphide gas (near hot spring, oil renery plant), such substances may lead

to failure of the unit.

2000mm

1000mm

300mm

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 66 67

Sin comentarios

McQuay M4MC Especificaciones Pagina 17