McQuay M5HDC Especificaciones Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 44
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
35
M5HDC-2010
Troubleshooting
Troubleshooting
Error Code
Heatpump Model (Universal Board)
Operation / Faulty Indication
Room sensor contact loose / short
Indoor coil sensor contact loose
Outdoor coil sensor contact loose
Compressor overload / Indoor coil sensor short /
Outdoor coil sensor short
Gas leak
N/A
Outdoor defrost (for Heatpump ony)
Error Code at 7 Segment Display
Blink E1
Blink E2
Blink E3
Blink E4
Blink E5
Blink E6
Blink Heat LED
Fault Condition
1. Fan does not work 3 minutes after
starting
Protection against the frequent starting. Wait 3 or 4 minutes.
2. The air conditioning unit does not
work
Power failure or need to replace the fuse.
The power plug is disconnected.
Possibility of making a programming error in the controller.
If the fault persist after these verifications, contact your installer.
The air filter is dirty.
The doors or windows are open.
The air entrance and exit are c
logged.
The reg
ulate temperature is not high enough.
4. The remote control light is deficient
The batteries are discharge.
The batteries are not correctly inserted.
The assembly is not good.
5. Air discharge flow has a bad odor
This odor can be caused by cigarette smoke particles, perfume,
sweat, which stick to the coil.
Check if there is any moisture on the walls, garment, other.
Check the drain pan.
6. Condensation on the air grille of
indoor unit
This is due to air hum
idity after a long time of operation.
The unit has a lower temperature point, increase the point and
operate at high speed.
7. The water flow of air conditioning
unit
Check the condensate evacuation.
8. The air conditioning unit are noisy
“Air flow noise” : refrigerant fluid admission in evaporator.
When any air-conditioner malfunction is noted, immediately switch off the power supply to
the unit, and contact the local dealer, if necessary. Some simple troubleshooting tips are
given below :
Fault
Cause
3. The air conditioning unit does not
blow sufficiently
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios